Tag Archives: evolis printhead

How to Remove and Replace an Evolis Pebble Printhead

Our technical area is busy with different questions our customers have about printers and how customers can get the most efficient operation from them. One popular question about the Evolis brand printers is about the printhead removal and replacement. The following video was prepared to demonstrate how to remove a printhead from the Evolis Pebble printer and then replace it wil a different printhead.

Steps:
1. Remove the hopper.
2. Open the top cover.
3. Push the support mechanism in to release the printhead.
4. Slide the printhead up and over the metal holder.
5. Unplug the wire harness.
6. Reverse the steps to put the new printhead into place.

Once the above steps are completed, the printer is ready for use.

If you need information about the Evolis printer brand, please contact our ID card experts at 888-485-4696.

Evolis Dualys 3 – Cleaning the Printhead

SafeCard ID presents a new video demonstrating how to clean the printhead in the Evolis Dualys 3 ID card printer.

How to clean the printhead in your Evolis Dualys 3 id card printer.

1. Unplug the power supply.
2. Open the top cover.
3. Take a cleaning swab and break the vial allowing the fluid to run down to the swab.
4. Wipe the swab back and forth across the printhead.
5. Close the top cover.
6. Plug back in the power supply. This will reset the printer and ribbon for your next print job.